MemoryToday.com
Memory UpgradeMemory Price ListMemory ForumsAbout MemoryToday

     LINE Chat

     Server HDD
ศูนย์รวม Hard Disk Drive สำหรับ Server รุ่นต่าง ๆ สอบถามได้ทันทีที่ Corporate Center: 02-641-0055

     Server Memory
ศูนย์รวมแรม Server และ Workstation ชนิดต่าง ๆ สอบถามได้ทันทีที่ Corporate Center: 02-641-0055

     Corporate Center
ดีลเลอร์ บริษัท องค์กร และหน่วยงานราชการ สามารถติดต่อโดยตรงไปยังกลุ่มผู้ดูแลลูกค้าพิเศษ เพื่อรับสิทธิพิเศษและเงื่อนไขการชำระเงินได้ที่ Corporate Center: 02-641-0055

     Who's Online
ขณะนี้มี 906 บุคคลทั่วไป และ 0 สมาชิกเข้าชม

ท่านยังไม่ได้ลงทะเบียนเป็นสมาชิก หากท่านต้องการ กรุณาสมัครฟรีได้ที่นี่

     Total Hits
มีผู้เข้าเยี่ยมชม
604435813
คน ตั้งแต่ กันยายน 2547

MemoryToday.com :: ดูกระทู้ - DIMM configurations
  คำถามถามบ่อยของกระดานข่าวคำถามถามบ่อยของกระดานข่าว  ค้นหาค้นหา  รายนามสมาชิกรายชื่อสมาชิก   ข้อมูลส่วนตัวข้อมูลส่วนตัว   เข้าระบบเข้าระบบ  เข้าระบบTo be member
DIMM configurations

 
ตั้งกระทู้ใหม่   ตอบกระทู้    MemoryToday.com หน้ากระดานข่าวหลัก -> MemoryToday.com : RAM Server : สอบถามราคา โทร.02-641-0055 จัดส่งด่วน
ดูกระทู้ก่อนนี้ :: ดูกระทู้ถัดไป  
ผู้ส่ง ข้อความ
TIM
Site Admin
Site Admin


เข้าร่วมเมื่อ: Oct 03, 2004
ตอบ: 2529

ตอบตอบ: Wed Jan 20, 2010 3:00 pm    ชื่อกระทู้: DIMM configurations ตอบกระทู้ด้วยเครื่องหมายคำพูด(quote)

MemoryToday.com :: ผู้ให้บริการเพิ่มแรม อันดับ 1 ของประเทศไทย!! จัดส่งและติดตั้งถึง Office และ EMS โทร. 02-874-4531

DIMM configurations

Single-sided and double-sided DIMMs

Each DRAM chip on a DIMM provides either 4 bits or 8 bits of a 64-bit data word. Chips that provide 4 bits are called x4 (by 4), and chips that provide 8 bits are called x8 (by 8). It takes eight x8 chips or sixteen x4 chips to make a 64-bit word, so at least eight chips are located on one or both sides of a DIMM. However, a standard DIMM has enough room to hold a ninth chip on each side. The ninth chip is used to store 4 bits or 8 bits of Error Correction Code (ECC).

An ECC DIMM with all nine DRAM chips on one side is called single-sided, and an ECC DIMM with nine DRAM chips on each side is called double-sided (Figure 7). A single-sided x8 ECC DIMM and a double-sided x4 ECC DIMM each create a single block of 72 bits (64 bits plus 8 ECC bits). In both cases, a single chip-select signal from the memory controller activates all the chips on the DIMM. In contrast, a double-sided x8 DIMM (bottom illustration) requires two chip-select signals to access two 72-bit blocks on two sets of DRAM chips.

Single-rank, dual-rank, and quad-rank DIMMs

In addition to single-sided and double-sided configurations, DIMMs are classified as to rank. A memory rank is defined as an area or block of 64-bits (72 bits for ECC memory) created by using some or all of the DRAM chips on a DIMM.

A single-rank ECC DIMM (x4 or x8) uses all of its DRAM chips to create a single block of 72 bits, and all the chips are activated by one chip-select (CS) signal from the memory controller (top two illustrations in Figure 7). A dual-rank ECC DIMM produces two 72-bit blocks from two sets of DRAM chips on the DIMM, requiring two chip-select signals. The chip-select signals are staggered so that both sets of DRAM chips do not contend for the memory bus at the same time. Quad-rank DIMMs with ECC produce four 72-bit blocks from four sets of DRAM chips on the DIMM, requiring four chip-select signals. Like the dual-rank DIMMs, the memory controller staggers the chip-select signals to prevent the four sets of DRAM chips from contending for the memory bus at the same time.

Memory ranks are not new, but their role has become more critical with the advent of new chipset and memory technologies and growing server memory capacities. Dual-rank DIMMs improve memory density by placing the components of two single-rank DIMMs in the space of one module. The chipset considers each rank as an electrical load on the memory bus. At slower bus speeds, the number of loads does not adversely affect bus signal integrity. However, for faster memory technologies such as DDR2-667, there is a maximum number of ranks that the chipset can drive. For example, if a memory bus on a server has four DIMM slots, the chipset may only be capable of supporting two dual-rank DIMMs or four single rank DIMMs. If two dual-rank DIMMs are installed, then the last two slots must not be populated. To compensate for the reduction in the number of DIMM slots on a bus at higher speeds, modern chipsets employ multiple memory buses.

If the total number of ranks in the populated DIMM slots exceeds the maximum number of loads the chipset can support, the server may not boot properly or it may not operate reliably. Some systems check the memory configuration while booting to detect invalid memory bus loading. When an invalid memory configuration is detected, the system stops the boot process to avoid unreliable operation.

To prevent this and other memory-related problems, HP urges customers to use only HP-certified DIMMs, which are available in the memory option kits for each ProLiant server (see the “Importance of using HP-certified memory modules in ProLiant servers” section).

Another important difference between single-rank and dual-rank DIMMs is cost. Typically, memory costs increase with DRAM density. For example, the cost of an advanced, high-density DRAM chip is typically more than twice that of a conventional DRAM chip. Because large capacity single-rank DIMMs are manufactured with higher-density DRAM chips, they typically cost more than dual-rank DIMMs of comparable capacity.



Information porvided by Hewlett-Packard Development Company, L.P.



Figure-7.jpg
 คำจำกัดความ:
Figure 7. Single-sided and double-sided DDR SDRAM DIMMs and corresponding DIMM rank
 ขนาดไฟล์:  161.12 กิโลไบต์
 เข้าชม:  14218 ครั้ง

Figure-7.jpg



_________________
MemoryToday.com โทร.02-641-0055 / 084-959-9000
Update ราคาล่าสุด! สอบถาม/ขอใบเสนอราคา โทรมาหาเราสิครับ!

กลับไปข้างบน
แสดงข้อมูลส่วนตัวของสมาชิก เข้าชมเว็บไซต์
แสดงการตอบก่อนนี้:   
ตั้งกระทู้ใหม่   ตอบกระทู้    MemoryToday.com หน้ากระดานข่าวหลัก -> MemoryToday.com : RAM Server : สอบถามราคา โทร.02-641-0055 จัดส่งด่วน ปรับเวลา GMT + 7 ชั่วโมง
หน้า 1 จากทั้งหมด 1

 
ไปยัง:  
คุณ ไม่สามารถ ตั้งกระทู้ใหม่ในกระดานนี้
คุณ ไม่สามารถ ตอบกระทู้ในกระดานนี้
คุณ ไม่สามารถ แก้ไขการตอบกระทู้ของคุณในกระดานนี้
คุณ ไม่สามารถ ลบการตอบกระทู้ของคุณในกระดานนี้
คุณ ไม่สามารถ ลงคะแนนในแบบสำรวจในกระดานนี้
คุณ สามารถ แนบไฟล์ในกระดานข่าวนี้
คุณ สามารถ ดาวน์โหลดไฟล์ในกระดานข่าวนี้





ผู้จำหน่าย RAM, SSD, HDD & Upgrade Parts สำหรับ Server อันดับ 1 ของประเทศไทย !!
RAM and SSD -> Server, Workstation, Apple Mac, Notebook, Desktop PC : Server Options -> Processor, Memory, SAS HDD, Storage Controller, Power Supply, Spare Part
© 2004-2023 MemoryToday.com, All rights reserved.
MemoryToday Co., Ltd. 7 IT-Mall Fortune Town Bldg., 3rd Floor, Room 3R22, Ratchadapisek Rd., Dindaeng, Bangkok 10400 Tel: 02-641-0055 Fax: 02-641-0066
Web site engine's code is Copyright by PHP-Nuke. All Rights Reserved. PHP-Nuke is Free Software released under the GNU/GPL license.